Quilted Potholders

DIY Quilted Potholder

I love to give homemade gifts for Christmas or birthdays, and I recently started making quilted potholders to gift to my family. For this tutorial, I made simple Christmas potholders.


You will need quilting cotton for the front, back, and binding, and Insulbright batting for the inside. I used 1/2 yard of the red and green, and 1/4 yard of the Winter Wishes print for my potholders. I also purchased 1/2 yard of Insulbright.

For your quilting cotton, come to Peekaboo Fabric Shop


I started the quilted potholders by cutting a 6.5 inch square of my white print for the center of my potholder. Then I cut 4 strips of red 2.5 inches by 6.5 inches and 4 squares of green that were 2.5 inches on all sides. Next, I cut a 12.5″ square of green for the back and two 12.5″ squares of Insulbright. My binding was cut at 2.5″ by the width of fabric for this size potholder. Your binding amount will be different depending on the size of your quilted potholders.

Piecing Together

First, piece the top of your potholder. I used a 1/4″ seam allowance and sewed each horizontal row together.

After sewing, press the seams in opposite directions as shown and then piece the rows together. Then I like to pin or clip at each seam to make sure they are matched.

Next, layer your backing, then two layers of Insulbright, and finally your quilt square. Then pin the layers together.

After pinning, quilt the layers together using the design of your choice. I chose to quilt around the center square and each corner square.

After quilting, square up your quilt block. I used my ruler to trim the potholder to be 10.25″ square.

Finishing the Edges

To finish the edges of the quilted potholders, press the binding strip wrong sides together. Pin the binding onto the wrong side of the potholder leaving the first 3-4 inches unsewn.

Stitch with a 1/4″ seam allowance stopping 1/4″ before the corner and back stitch.

Next, fold the binding to the right at a 45 degree angle.

Then fold the binding back onto itself even with the right edge of the potholder. Begin stitching 1/4″ from the corner and continue this process for each corner.

When all 4 corners are sewn, fold the beginning end of the binding strip in 1/2″. Then place the final end inside the folded binding to encase the raw edges. Stitch to where to the binding stitching began and backstitch to finish. The folded edge is visible just above my fingers in the below photo.

Flip the potholder to the right side and fold the binding around encasing the raw edge of the potholder. Topstitch just inside the folded edge of the binding. Fold the corners around to form a 45 degree miter on the front as well.

Here is the finished view of the front binding sewn.

I can’t wait to see your finished potholders. These would be lovely paired with Genie’s personalized dish towels from the blog last week. Have a wonderful holiday season!

Leave a Reply

Your email address will not be published.



Get 25+ FREE

Sewing Patterns


The Coupon Code for the 25+ Free Patterns is in your E-mail.



Keep enjoying our Blog or check out our Website


for great deals on sewing patterns and fabric!